Skip to content
Techcon

PLASTICS STANDARDS 2026

High-quality plastic dispensing syringes, cartridges, components, and needles used by the most demanding industries in the world.

Techcon is proud to announce our new level of quality standards for cleanliness, consistency, purity, resistance to impact, high pressure, or extreme temperatures, for all our plastic packaging products.

Techcon Plastics Guide 2026

Download Now

700_Series_ClearRedBlackCarts_Collage_lp

Our focus is not on meeting standards set by local, national, or global authorities.

Our focus is on exceeding your standards.

And continuing to raise our own.

When you purchase from our line of high-quality dispensing plastics, you can rest assured each piece was produced while adhering to the TECHCON PLASTICS STANDARD:

  • Meet or exceed industry standards for repeatability
  • Meet or exceed industry standards for UV blockage
  • Meet or exceed global ROHS and REACH standards
  • Achieve Impact resistance two-times industry requirements
  • Produced in a Silicon-free, Chloride-free environment
  • Approved for operating pressures up to 100 psi/6.9 bar
  • Approved for storage temperatures as low as -40 ⁰F/-40 ⁰C and as high as 100 ⁰F/38 ⁰C
     
Techcon Plastics Guide 2026

Techcon Plastics are accepted by the aerospace, medical device, automotive, consumer electronics, and military & defence sectors

Techcon Plastics Standards require that all plastics are completely free of:

✓ Loose Debris
✓ Contamination
✓ Blush
✓ Flow Lines
✓ Knit Lines
✓ Weld Lines
✓ Loose Debris, Contamination
✓ Cold Slugs
✓ Delamination
✓ Orange Peel
✓ Cracking
✓ Crazing
✓ Nicks/Gouges
✓ Waviness
✓ Grease
✓ Luricants
✓ Burns
✓ Gas Marks
✓ Marbling

See the Glossary in the Techcon Plastics Guide for definitions of these terms

Scott

Techcon warrants our plastic packaging products against dimensional issues, visual defects, or damage 

See the Warranty section of the Plastics Guide for details

Contact Techcon for more information
North America - Worldwide Headquarters

OK International/ Techcon

10800 Valley View Street

Cypress, CA 90630

U.S.A.

Tel: 1-714-230-2398

Fax: 1-714-230-2393

Email: eorders@okinternational.com

European Corporate Office

OK International/ Techcon

Eagle Close, Chandler's Ford

Hampshire, SO53 4NF

U.K.

Tel: English +44 (0) 23-8048-9100

Tel: Français: +33 176-710-403

Tel: Deutsch: +49 711 959 69 744

Email: europe-orders@okinternational.com

China Corporate Office

OK International/ Techcon

4th floor East, The Electronic Building

Yanxiang Industrial Zone

High Tech Road, Guangming New District

Shenzhen, P.R.C.

Tel: +86-755-2327 6366

Fax: +86-755-2329 5492

Email: china@okinternational.com